• Ribbons, Foils

    • Thickness 0,1 mm – 2,1 mm
    • Width < 300 mm
    • Length nach Wunsch
  • Rods, Bars

    • Diameter ca. ca. 12,5 mm – 215 mm
    • Length < 4000 mm (smaller standard sizes are available)
  • Mögliche weitere Veredelung

    Wir längen ab, besäumen, teilen, biegen, stanzen, schweißen und glühen – von einfachsten Formen bis zu komplizierten Geometrien.

    Mehr erfahren
  • Wärmebehandlung

    Bitte beachten Sie, dass bis auf wenige Ausnahmen nach Abschluss der mechanischen Bearbeitung eine Wärmebehandlung zur Einstellung der weichmagnetischen Eigenschaften zwingend notwendig ist.

    Mehr erfahren

Properties of material

50 % CoFe-alloys (VACOFLUX® and VACODUR®) are the first choice for applications with demands concerning high magnetic flux densities (e.g. in flux concentrators, flux conductors). They are in particular suited for magnetic shieldings against strong fields, for magnetic yokes (for example in particle accelerators) and for motors and generators, where a maximum torque at a small volume is necessary. CoFe-alloys are brittle by nature and tend to “crumble” slightly if milled/turned. The correct thermal annealing is very important for the family of CoFe alloys. If not done properly the magnetic parameters will be significantly worse than the typical alloy data.  VACOFLUX® is a versatile alloy with a broad spectrum of use, while VACODUR® allows to apply different thermal treatments, one optimizing the mechanical properties (with still superior magnetic properties) while the other generates optimal magnetic properties. This makes this alloy very useful for motor applications: The mechanically burdened rotor usually receives the mechanical annealing and stator the magnetic annealing treatment. Nevertheless both lamination types can be stamped or lasercut from one sheet of material, minimizing material losses!

Typical magnetic properties after annealing
AlloyCompositionµ4 (50 Hz)HC [A/m]BS [T]TCurie [°C]Thermal expansion [10-6/K] (20...100°C)Specific electrical resistance [µOm]Density[g/cm³]
VITROVAC® 6025 X80 % Co2000010,58200121,357,7
VACOPERM® 10080 % NiFe9000020,7840013,50,68,7
MUMETALL®80 % NiFe5000030,8040013,50,68,7
PERMENORM® 5000 H250 % NiFe12000101,55440100,458,25
VACOFLUX® 50 (strip)50 % CoFe1000902,359509,50,358,12
VACOFLUX® 50 (massive)50 % CoFe1000 (static)2002,359509,50,358,12
Soft Iron99,9 % Fe1000 (static)802,15770 0,1077,86
CRYOPERM® 1080 % NiFe**** 0,358,7
TRAFOPERM® N33 % SiFe1000 (static)252,03750120,47,65
µ4: µr at 0,4 A/m